Table of Contents
Advertisement
Installing the Module
Use this chapter to install the module. This chapter describes:
• an overview of the general installation procedure
• how to connect the module to a host through the RS-232C serial port
• how to connect the module to a host through the parallel port
• how to connect the module to a host through the isolated network access port (NAP)
• how to connect the module to the ControlNet cable system
• how to attach the module to a wall or mounting bracket
Pinout and wiring details are provided in Appendix B, Cabling and Pinouts. Read this if you
need to construct cables. If a tap is not available on the ControlNet cable system for the
module, refer to the ControlNet Cable System Planning and Installation Manual,
CNET-IN002, to determine if your cable system can accommodate another node and to plan
where to mount the tap, then follow the mounting instructions at the end of this chapter.
Electrostatic Damage
ATTENTION
!
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Electrostatic discharge can damage semiconductor devices inside the
module. To guard against electrostatic damage wear an approved wrist
strap grounding device, or touch a grounded object to rid yourself of
electrostatic charge before handling the products.
Publication 1770-UM520C-EN-P - July 2004
3
Chapter
Advertisement
Table of Contents
