Table of Contents
Advertisement
What This Chapter Contains
Installing the Software
1
Configuring the DeviceNet Network
This chapter describes how to configure the DeviceNet network using
RSLinx and RSNetWorx for DeviceNet software. The following table
describes what this chapter contains and where to find specific
information.
For information about
Installing the Software
Using RSLinx to Configure the DeviceNet Driver
Using RSNetWorx to Configure the 1756-DNB Module Scanlist
Setting Up an Online Connection
Setting the 1756-DNB Node Address
Configuring the Scanlist
Verifying the RediSTATION Configuration
AutoMapping the Devices into the Scanlist
Saving the DeviceNet Configuration
For both the RSLinx and RSNetWorx software.
1. Insert the installation CD in the CD-ROM drive.
Note: The CD-ROM supports Windows Autorun. Once inserted into
the CD-ROM drive, if you have Autorun configured, the installation
will automatically start at the first setup screen.
If Autorun is not configured for your CD-ROM drive, go to step 2.
2. From the Start menu, choose Run.
You will see the Run pop-up window.
3. Type d:/setup (if it doesn't appear automatically), where d: is your
CD-ROM driver letter.
4. Click on OK.
You will see the progress bar, followed by the welcome screen.
4
Chapter
See page
4-1
4-2
4-4
4-4
4-6
4-9
4-14
4-15
4-18
Publication 1756-6.5.19 - May 2000
Advertisement
Table of Contents
