Omron K6CM Startup Manual page 33

¢ K6CM-VB (Vibration type)
The alarm threshold of acceleration and velocity can be set automatically by entering the motor information to be
monitored in the software tool.
(1) Click the [Guide for Setting Alarm (K6CM_VB)] button (
Enter the information of the motor to be monitored on the following screen.
● When setting acceleration alarm
[1] Enter the shaft diameter.
If the shaft diameter is unknown, click the [Ref. Shaft diameter] button.
Refer to the following table and enter the shaft diameter from the frame number.
* Check the motor plate or motor manual for the frame number.
* The following table is taken from IEC 60072-1.
For frame numbers that are not listed in the table below, check the shaft diameter from the motor manual.
[2] Enter the rotation speed (rpm) or drive frequency (Hz).
When entering the drive frequency, enter the number of poles as well.
* Check the motor plate or motor manual for the number of poles.
) on the device setting screen.
Motor plate example
Motor plate example
33