Omron K6CM Startup Manual page 16

Click the LAN card tab, and select the LAN card in the PC to use in communications with K6CM.
LAN card configuration example:
I f there is only one wired LAN port of the PC and the Motor condition monitoring Tool communicates with the K6CM
device with that wired LAN port, select the following.
(If the name of the network connection has been changed, select the one with the changed name.)
Windows 7
Select a LAN card in the "Name" field is "Local Area Connection" is displayed.
Windows 8.1/Windows 10
Select a LAN card that is displayed is "Ethernet" in the "Name" field.
Next, click the IP address tab, select the IP address to use in communications, then select [OK].
Do not select AutoIP address (169.254.xxx.xxx: x is an arbitrary number).
If IP addresses other than the AutoIP address are not displayed, the IP address of the PC is not set.
Next, select [File] | [End].
6 Select [[K6CM] Create the project].
A file that incorporates settings and device configuration is called a "Project".
From the Motor condition monitoring Tool Startup screen, select [[K6CM] Create the project].
The following screen is displayed.
Click the [OK] Button.
When connecting the PC and K6CM with a one-to-one connection, select [Automatic connection].
(When connecting the PC and K6CM with a one-to-many connection via a hub, select [Fixed IP connection].
For details, refer to the User's Manual (N219).)
16
CAUTION