Download Print this page

Omron K6CM Startup Manual page 21

Motor condition monitoring device
Hide thumbs Also See for K6CM:

Advertisement

This opens the following monitor screen for each motor unit.
Click the [Save the project file] button (
7 Confirm motor status can be monitored
The default settings for the monitoring cycle is 600 seconds. In this state, starting monitoring means that it will take 600
seconds to obtain initial data. Accordingly, it takes time to confirm whether or not the motor status is being monitored.
Initially, temporarily set a short monitoring cycle (for example, 5 seconds) to confirm if the motor status is being measured.
The procedure for this is as follows.
Click the (
) device setting button, and click the (
The following [K6CM Monitoring Settings] screen will be displayed.
Set the monitoring cycle to 5 seconds, then click the [OK] button.
Version Information
With software tool version 1.2.0.0 or later, the unit of monitoring cycle can be set.
) for the created project to save.
) [Option] button.
Using this pull down list allows
you to change the unit of
monitoring cycle.
Selectable units are seconds,
minutes, hours, and days.
21

Advertisement

loading