Omron K6CM Startup Manual page 14

3 PC IP address setting
Windows 7
(1) Select [Start] | [Control Panel] | [Network and Sharing Center] | [Change Adapter Settings].
(2) Right-click [Loca Area Connection] and select [Properties].
(3) Select [Internet Protocol Version 4 (TCP / IPv4)] and click [Properties].
Check "Use next IP address" and manually set the IP address of the PC.
Windows 8.1
(1) Right-click [Start].
(2) Select [Network connection].
(3) Right-click [Ethernet], and click [Properties].
(4) Select [Internet Protocol Version 4 (TCP / IPv4)] and click [Properties].
Check "Use next IP address" and manually set the IP address of the PC.
Windows 10
(1) Click [Start] and select [Windows System Tools] | [Control Panel].
(2) Select [Network and Sharing Center] | [Change adapter settings].
(3) Right-click Ethernet and click Properties.
(4) Select [Internet Protocol Version 4 (TCP/IPv4)] and click [Properties].
Check "Use next IP address" and manually set the IP address of the PC.
IP Address Settings Example
When using Ethernet for the first time, if you set the IP address and subnet mask of the PC and K6CM device as below, it
is possible to connect the Motor condition monitoring Tool to the K6CM device.
Device name
PC
K6CM device 1st Unit
K6CM device 2nd Unit
K6CM device 3rd Unit
:
K6CM device 30th Unit
When the subnet mask is "255.255.255.0", the range of IP addresses that can be set for the device is 192.168.250.1 to
192.168.250.254. Assign IP address in this range to each K6CM device.
The same IP address can not be assigned to more than one device.
The default value of the IP address of type K6CM device is "192.168.250.10" common to all models.
4 Motor condition monitoring Tool start-up
Windows 7
Select [All Programs] | [OMRON] | [Motor condition monitoring tool].
Windows 8.1
Select [Start] | [All Programs] | [OMRON] | [Motor condition monitoring tool].
Windows10
Select [Start] | [OMRON] | [Motor condition monitoring tool].
The Motor condition monitoring Tool starts and the following screen is displayed. This screen is called "start screen".
14
IP address
192.168.250.100 255.255.255.0
192.168.250.1 255.255.255.0
192.168.250.2 255.255.255.0
192.168.250.3 255.255.255.0
:
192.168.250.30 255.255.255.0
Sub-net mask
Blank
No change required (0.0.0.0)
No change required (0.0.0.0)
No change required (0.0.0.0)
:
No change required (0.0.0.0)
Default gateway
: