Integration Into The Control Environment; Start-Up Files And Description Of The Process Data And Parameters; Plc Compatibility - Burkert AirLINE 8652 Series Operating Instructions Manual

10 INTEGRATION INTO THE CONTROL
ENVIRONMENT
10.1 Start-up files and description of the process data and
parameters
The start-up files required by the project planning software are available on the Internet.
Download the start-up files from:
country.burkert.com
You will also find the descriptions of the start-up files in the zip file.
→
Use the latest start-up file from the "01_Standard" folder (exception: see Chapter"10.2" ).
The description of the CANopen standard objects can be found under:
country.burkert.com
10.2

PLC compatibility

If new devices are to be operated with the start-up files of an older software version, e.g. because a
replacement device is to be used in an existing automation system, this can be done without issue by con-
verting the PLC compatibility.
The currently installed software is shown under
fieldbus gateway.
Convert compatibility mode via the display of the fieldbus gateway:
"12.4 Converting compatibility mode" on page 63
Convert the compatibility mode via the Bürkert Communicator:
"16.2.6 Converting compatibility mode" on page 74
10.2.1 Compatibility mode and start-up files
Download the start-up files from:
country.burkert.com
In "Device Description Files.zip" there are sub-folders "01_Standard" and "02_Extension_Modules" in each
fieldbus folder (see Chapter "16.8 Using Extension Modules (EM)" ).
Please note the release notes in the respective folder in order to use the appropriate version of the start-up
file.
46
→ Type 8652 → Software → Device Description Files.zip
→ Type 8652 → Operating instructions → "CANopen network configuration"
→ Type 8652 → Software → Device Description Files.zip
English

Integration into the control environment

Maintenance > SW version
Type 8652
on the display of the