Combine Valve Island With External Di Modules; Assign Position Feedback Sensor Source In The Automation Software; Assign Position Feedback Sensor Source In Bürkert Communicator - Burkert AirLINE 8652 Series Operating Instructions Manual

Modular valve island for pneumatic

Table of Contents

COMBINE VALVE ISLAND WITH EXTERNAL DI

MODULES

If the number of digital inputs (DIs) on the valve island is insufficient or the valve island does not have DIs,

external DI modules can be added as position feedback sensor sources.

External DI modules can, for example, be B. 8DI modules of type ME44 or 16DI modules of type ME64.

The start-up files of the valve island already contain the settings of the external DI modules.

Download the start-up files from: country.burkert.com

Description Files.zip

Steps required:

1. Assign position feedback sensor source in the automation software (see"20.1" ).

2. Assign position feedback sensor source in Bürkert Communicator (see"20.2" ).

3. Carry out network configuration in the Bürkert Communicator (see "20.3").

4. Set the display of error messages in the Bürkert Communicator (see "20.4").

These settings must be made separately for each valve unit.

Alternatively: required steps via a wizard:

If the configuration is identical for each valve unit, it is recommended to use a wizard in the Bürkert Commu-

nicator. The procedure is described in Chapter "20.5 Configure external DI modules using a wizard".

20.1

Assign position feedback sensor source in the

automation software

CAUTION

With PROFIBUS and PROFINET, the settings in the automation software overwrite the settings in the

Bürkert Communicator.

Make sure that the settings are identical in both programs.

►

For the external DI modules, the position feedback sensor source is always "büS" or "büS network".

Information on start-up with automation software can be found in Chapter"10 Integration into the control

environment" on page 46 .

20.2

Assign position feedback sensor source in Bürkert

Communicator

The position feedback sensor source must be assigned to each valve unit separately.

In the valve island configuration area

User level: Installer

→

Choose unit.

→

Select the source for the upper end position and the lower end position under

feedback sensor.

English