Xerox D125 User Manual page 89

Fault code Cause and Remedy
116-740 Cause: Numerical value operation error occurred as a value exceeding the value
limit of the printer was used in the print data.
Remedy: Check the print data.
116-747 Cause: There are too many paper margin values for the HP-GL/2 effective
coordinate area.
Remedy: Reduce the paper margin values, and instruct it to print again.
116-748 Cause: There is no plot data in the HP-GL/2 print data.
Remedy: Check the print data.
116-749 Cause: Job cancelled because the specified font was unavailable.
Remedy: Install the font or set up a font replacement on the print driver side.
116-771 Cause: There was a problem with parameters in the JBIG data. They were
116-772 automatically edited.
116-773 Remedy: If any problem occurs in job result, try to process the job again.
116-774
116-775
116-776
116-777
116-778
116-790
116-780 Cause: There is a problem with the document attached to the received mail.
Remedy: Check the attached document.
124-345 Cause: A malfunction occurred in the machine.
124-346 Remedy: Power-cycle the machine. If the machine error is not fixed by performing
124-347 the relevant remedy, contact the Customer Support Center.
124-348
124-349
127-210 Cause: Communication error between the printer and the controller. Error detected
by the printer.
Remedy: Remove and reinsert the cable connection between the printer and the
controller. Power off and on both the printer and the controller. If the problem
persists, call the Customer Support Center.
127-211 Cause: Detected a communication error between the printer and the controller.
Remedy: Remove and reinsert the cable connection between the printer and the
controller. Power off and on both the printer and the controller. If the problem
persists, call the Customer Support Center.
127-212 Cause: Detected an internal print check error by the controller.
Remedy: Remove and reinsert the command/video cable between the controller
and the printer. Power off and on both the printer and the controller. If the problem
persists, call the Customer Support Center.
127-213 Cause: Detected a mismatch with the software version of the controller.
Remedy: Contact the Customer Support Center for information and/or instructions
to remedy the problem.
®
Xerox D110/D125/D136 Printer
User Guide
Problem solving
10-23