Fault Codes - Xerox D125 User Manual

Standard/Booklet Maker Finisher
8. Push a new staple cartridge into the unit.
9. Reinstall the cartridge unit to its original position in the finisher.
10. Close the right cover on the finisher.
Note
A message will display and the machine will not operate if the right cover is open
even slightly.

Fault codes

If an error caused the printing to end abnormally, or a malfunction occurred in the
Booklet Maker Finisher, then an error code is displayed.
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
If an error code is displayed, all print data of the machine as well as print data stored
in the machine's built-in memory is discarded.
012-125
Cause: The finisher malfunctioned.
Remedy: Perform the following:
Power off/on the machine, and if necessary, resend/restart your print job.
If the error persists, contact the Customer Support Center.
Check for any obstructions in the paper path and clear them.
012-132
Cause: The finisher malfunctioned.
Remedy: Perform the following:
16-36 User Guide