Table of Contents
Advertisement
4 Install Lock body
1. Wires and connectors go into the mortised area and out of the
inside cylinder hole.
2. Insert mortise lock body into mortise door preparation.
3. Carefully feed wires from mortise lock through the non-cylinder
side hole of the door preparation.
4. Install appropriate hardware lock body screws.
NOTE: Do not tighten screws completely at this time.
Cylinder should be installed prior to tightening.
Fig. 4B
5 Outside Escutcheon and Mounting Plate Installation
NOTE: Feed mortise connectors through the corresponding
hole on the mounting plate.
1. Attach the mounting plate using (2) 8-32 x 3/8" Phillips flat
head undercut combo screws in the upper left and middle
right positions of the mounting plate and (2) 8-32 x 3/8"
Phillips flat head screws in the bottom positions (Fig. 5A).
Harmony Series IDP-H1 Mortise Lock
IDP Switch
(2)#12 x 1-1/4" Long Flat Head Wood
Screws (Wood Doors)
8
A8132C • 800-810-WIRE (9473) • www.sargentlock.com
(2) #12-24 x 1/2" Long Flat
Head Philips Screws (Metal Doors)
Fig. 5A
Feed connectors
and wires through
non-cylinder side.
Fig. 4A
Inside of Door
(2) 8-32 x 3/8" Phillips
Flat Head Undercut
Combo Screw
(2) 8-32 x 3/8"
Phillips Flat
Head Screw
Advertisement
Table of Contents
