Table of Contents
Advertisement
Harmony Series IDP-H1 Mortise Lock
10 Install Outside Lever and Inside Adapter Plate Assembly
1. With outside lever horizontal, insert the mounting post through outside of door and lock body.
Make certain the lever spindle is properly engaged inside the lock body (Fig 9A).
2. On the inside of the door, insert spindle into square hole of mortise lock (Fig 9B).
3. Slide inside adapter and plate
assembly over spindle and
loosely secure with (2) 8-32 X 5/8"
Phillips oval head and lock washer
machine screws.
Be sure to rotate set screw hole
so that hole (Studio Collection only)
faces the hinge side and seat the
inside spindle fully into lock body.
4. Securely tighten the
lock body screws.
11 Attach Connectors (Interior PCB Assembly)
1. Connect P3 (2-pin connector) from lock body to J3 on interior
PCB assembly.
2. Connect P4 (6-pin connector) from lock body to J4 on interior
PCB assembly.
3. Connect P5 (7-pin connector) from Reader board to J5 on interior
PCB assembly.
4. Connect ElectroLynx harness (4 and 8-pin) from door harness
to ElectroLynx harness on interior PCB assembly.
NOTE: Connectors go on only one way.
Do not offset connector and be sure they are completely seated.
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
1-Violet
3-Pink
Lock NEG
DPS (NC)
2-Gray
4-Tan
Lock POS
DPS (COM)
A8132C • 800-810-WIRE (9473) • www.sargentlock.com
Outside of Door
Fig. 9A
J1
1- Black
3-White
5-Orange
PWR NEG
DATA 1
RX (NO/NC)
2-Red
4-Green
6-Blue
PWR POS
DATA 0
RX (COM)
Fig. 10B
11
J2
To ElectroLynx Harness
From Lock
Body P4 to J4
7-Brown
EGND
8-Yellow
LED
Inside of Door
8-32 X 5/8"
Phillips Oval
Head and
Lock Washer
Machine
Screws (2)
Fig. 9B
From Reader
Board P5 to J5
J5
J1
J3
J4
J3
From Lock
Body P3 to J3
Fig. 10A
Advertisement
Table of Contents
