Table of Contents
Advertisement
Harmony Series IDP-H1 Mortise Lock
Typical Harmony Mortise Application Diagram (12/24VDC System)
DIAGRAM #3 – MODE 3: LED WIRE TO EAC PANEL = EAC PANEL CONFIGURABLE
Standard Application Shown - For Alternative Applications Contact 1-800-810-WIRE (9473)
12 Conductor
ElectroLynx Harness
From McKinney
Strike
(with magnet)
Max. gap
H1 Harmony Series
between door &
strike is 1/4"
NOTE:
If your lock is configured with End of Line Resistors,
reference instruction sheet A8191 for the wiring of
RX & DPS outputs.
A8132C • 800-810-WIRE (9473) • www.sargentlock.com
Reader Electronics Requires 12VDC Filtered and Regulated
12/24VDC System
•
Reader Draw = 140mA @12VDC
•
Actuator Draw = 15mA continuous
•
Maximum 2 locks per 1 Amp power supply (1/2 Amp peak current draw)
The H1 reader requires 12VDC for power.
As the lock accepts 12-24V, a 12V power
supply is recommended to support both the
lock and reader with a single power supply.
READER NEG - Black, 1
READER POS - Red, 2
QC12 Electric
DATA 1 - White, 3
Hinge From
DATA 0 - Green, 4
McKinney
RX (NO/NC) - Orange, 5
RX (COM) - Blue, 6
*EGND- Brown, 7
LED - Yellow, 8
LOCK NEG - Violet, 9
LOCK POS - Gray, 10
DPS (NC) - Pink, 11
DPS (COM) - Tan, 12
*IMPORTANT: Pin 7 must be tied to earth ground in the access control panel.
Failure to follow proper ESD safe grounding procedures could lead to equipment failure.
H
N
G
120 VAC
Input
12/24VDC
-
+
(-)
(+)
DATA 1
DATA 0
RX
RX
LED
DPS
DPS
17
Lock body
Power Supply
(By Others)
Electronic
Access
12VDC
Control
Panel
(By Others)
Use (NC) for
Fail Safe
Operation
Lock Relay
(NO) Fail
Secure
Operation
Advertisement
Table of Contents
