Table of Contents
Advertisement
Industrial Electronic Devices
SET SDO SERVER:
By pressing the
"Set SDO
Server" button from the main window
for SW67804 (Fig. 2) the window "Set SDO Server Access" appears
(Fig. 5).
This window is made to create the SDO in read or write in the
CANopen side, and to indicate which byte are associated to these
SDOs.
It is divided in two parts, the "SDO in read" and the "SDO in Write".
The first part is used to read, using the SDO, the data arrived from
the KNX devices. The second is used to write, using SDO, the data
that will be sent to the KNX devices.
The data of the columns have the following meanings:
In the field "Index" the address of the SDO is defined;
In the field "SubIndex" the second address of the SDO is
defined;
If the field
"N
Byte" the dimension of the SDO is defined (it
can be 1, 2 or 4);
In the field
"Address
Byte1" insert the address of the KNX
arrays where read/write first byte of the SDO;
In the field
"Address
Byte2" insert the address of the KNX
arrays where read/write second byte of the SDO (only if N
Byte is 2 or 4);
In the field
"Address
Byte3" insert the address of the KNX arrays where read/write third byte of the SDO (only if N Byte is 4);
In the field
"Address
Byte4" insert the address of the KNX arrays where read/write fourth byte of the SDO (only if N Byte is 4);
In the field "Mnemonic" the description for the SDO is defined.
It is possible to configure a maximum of 1000 SDOs (500 in read and 500 in write) in the "Set SDO Server Access" section.
ADFweb.com Srl – IT31010 – Mareno – Treviso
User Manual CANopen / KNX
Document code: MN67804_ENG
Figure 5: "Set SDO Server Access" windows
INFO:
www.adfweb.com
Revision 1.001
Pagina 19 di 29
Phone +39.0438.30.91.31
Advertisement
Table of Contents
