Table of Contents
Advertisement
User Manual CANopen / KNX
Document code: MN67804_ENG
Revision 1.001
Pagina 12 di 29
Industrial Electronic Devices
ETHERNET (PROGRAMMING PORT):
The Ethernet ports are used for programming the device.
The Ethernet connection must be made using Connector2 of HD67804-KNX-B2 with at least a Category 5E cable. The maximum length of the
cable should not exceed 100m. The cable has to conform to the T568 norms relative to connections in cat.5 up to 100 Mbps. To connect the
device to an Hub/Switch is recommended the use of a straight cable, to connect the device to a PC is recommended the use of a cross cable.
ADFweb.com Srl – IT31010 – Mareno – Treviso
INFO:
www.adfweb.com
Phone +39.0438.30.91.31
Advertisement
Table of Contents
