Table of Contents
Advertisement
Industrial Electronic Devices
If you know the actual IP address of the device, you have to use this procedure:
Turn on the Device with the Ethernet cable inserted;
Insert the actual IP of the Converter;
Press the "Ping" button, must appear "Device Found!";
Press the "Next" button;
Select which operations you want to do;
Press the
"Execute update
When all the operations are "OK" the device automatically goes at
Normal Mode.
At this point the configuration/firmware on the device is correctly update.
Note:
When you install a new version of the software, if it is the first time it is better you do the update of the Firmware in the HD67804
device.
Note:
When you receive the device, for the first time, you also have to update the Firmware in the HD67804 device.
Warning:
If Fig. 9 appears when you try to do the Update try these points before seeking
assistance:
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
If you are using the program inside a Virtual Machine, try to use in the main Operating
System;
If you are using Windows Seven or Vista or 8, make sure that you have the
administrator privileges;
Take attention at Firewall lock;
Check the LAN settings.
In the case of HD67804 you have to use the software "SW67804": www.adfweb.com\download\filefold\SW67804.zip.
ADFweb.com Srl – IT31010 – Mareno – Treviso
firmware" button to start the upload;
User Manual CANopen / KNX
Document code: MN67804_ENG
Figure 9: "Protection" window
INFO:
www.adfweb.com
Phone +39.0438.30.91.31
Revision 1.001
Pagina 25 di 29
Advertisement
Table of Contents
