Ide Connector Installation - SOLTEK B7A-F User Manual

B7A-F

2-4 IDE Connector Installation

To install IDE Connector, you may connect the blue connector of IDE
cable to the primary (IDE1) or secondary (IDE2) connector on board,
and then connect the gray connector to your slave device and the black
connector to your master device. If you install two hard disks, you must
configure the second drive to Slave mode by setting its jumpers correctly.
Please refer to your hard disk documentation for the jumper settings.
Hard Disk Drive Connector
Orient the red line on the
IDE Flat Cable to Pin1.
80-conductor IDE Cable
(with Slave Connector)
This kind of cable is not recommmended
for the Mini-barebone system because
the ribbon cannot be bundled up and will
block the air flow in the barebone cabinet.
Red line
Black connector
(To Master Device)
Pin 1 (to Red Line)
Gray connector
(To slave device)
Blue connector
(To Mainboard)
AC'97
Codec
RTL
ALC650
ICS 1893
FW803
1394A
JP3
Fan2
JCLK2
JUSB1
1
USB3
1
USB2
DIMM2 DDR 333/266 MHz
DIMM1
Li
Battery IDE2
IDE1
JBAT1
IDE1
IDE2
80-conductor IDE Cable
(dedicated for Barebone)
This kind of cable is dedicated for Mini-
barebone system because the ribbon
can be bundled up and will not block
the air flow in the barebone cabinet. A
dedicated cable with a gray connector
for a slave device is an optional item in
the Mini-barebone System.
Bundle Strap
80-conductor
IDE cable
Blue connector
(To Mainboard)
22
TV1
JP2
JKB1
COM2
JCLK1
LPC I/O
W83627HF
Fan1
FDC1
PW1
+12V Power
Fan3
PW2
Main Power
Red line
Black connector
(To Master Device)