Vga / Agp Slot Installation - SOLTEK B7A-F User Manual

2-3 VGA / AGP Slot Installation

1. To install onboard VGA, please connect your monitor directly to either
or both VGA connectors on board. The onboard VGA connectors
support simultaneous Dual Display. On the other hand, VGA1 is the
Master VGA channel for VGA connection, but VGA2 is the second
VGA channel for VGA/S-Video select.(For the second VGA/S-Video
select, please refer to Jumper Jp2 set-up.)
2. The AGP slot on board supports 1.5V AGP 8X/4X card only. A Rib is
specifically added to the 8X/4X slot so as to match the AGP 8X/4X
card. To insert a 3.3V AGP 2X card into the AGP 8X/4X slot will
damage the system chip and burn the 1.5V circuitry.
An AGP 8X card will support a data transfer rate up to 2GB/sec,
while an AGP 4X card will provide 1GB/sec transfer rate.
3. When AGP is used on board, either VAG1 or VGA2 can be selected
to match with AGP for dual-channel display.
Dual Channel VGA Display
VGA1 Connector
VGA2 Connector
Jp2
2nd VGA/TV-Out Select
1-2 closed
1
TV Out Enabled
(2nd VGA Disabled)
2-3 closed (default)
1
2nd VGA Enabled
(TV Out Disabled)
Chapter 2 Hardware Setup
AGP Accelerator
notch
IEEE1
IEEE2
PCI 1
AGP1 8X/4X
Jp2
21
AGP 8X/4X Slot
HDD LED IR PWR
-
+
20
-
+
SPK RST PWLED