Floppy Drive Connector Installation - SOLTEK B7A-F User Manual

2-5 Floppy Drive Connector Installation

To install FDC, you should connect the end of FDC cable with single
connector to the board, and connect the other end with two connectors
to the floppy drives.
AC'97
Codec
RTL
ALC650
ICS 1893
JP3
Fan2
JCLK2
JUSB1
1
USB3
1
USB2
DDR 333/266 MHz
DIMM2
DIMM1
Li
Battery
JBAT1
34-pin FDC cable
(w/2nd Connector)
This kind of cable is not recommmended
for the Mini-barebone system because
the ribbon cannot be bundled up and will
block the air flow in the barebone cabinet.
To 2nd Floppy Drive
To 1st Floppy Drive
Red line
TV1
JP2
JKB1
COM2
FW803
JCLK1
1394A
LPC I/O
W83627HF
Floppy Drive Connector:
Fan1
FDC1
Orient the red line of the
Floppy Flat Cable to Pin1.
PW1
+12V Power
Fan3
PW2
IDE2
Main Power
IDE1
To mainboard
Chapter 2 Hardware Setup
Pin 1 (to Red Line)
34-pin FDC cable
(dedicated for Barebone)
This kind of cable is dedicated for Mini-
barebone system because the ribbon
can be bundled up and will not block
the air flow in the barebone cabinet. A
dedicated cable with 2nd connector for
2nd floppy drive is an optional item in
the Mini-barebone System.
Signal Swap
End
To 1st Floppy Drive
23
Red line
To mainboard