Table of Contents
Advertisement
Configuration
4.10 Data points
● Time trigger
For time triggers, select the value of the cycle and the respective unit of time from the
drop-down list.
– Cyclic
– Once daily
– Once weekly
– Once monthly
● Value trigger
Select the type using the drop-down list and add the respective values.
The value ranges of the value triggers depend on the data type of the data point.
– Deviation
– Area outside
– Area within
– Threshold HIGH
– Threshold LOW
Note:
The range of values of the station data point is converted to the range of values of the
device data point.
● Input trigger
– Digital input
106
The value of the data point is transferred cyclically. Ranges of values:
100 .. 100 000 000 ms
1 .. 1 000 000 s
1 .. 1666 min
1 .. 27 h
The value is transferred once a day at the configured time.
The value is transferred once a week.
The value is transferred once a month.
If a month has fewer days than the day specified in the configuration, the value of the
data point is transferred at the end of the month.
The value is transferred as soon as it changes compared to the value that was read in
before.
The value is transferred as soon as it is outside the configured area.
The value is transferred as soon as it is inside the configured area.
The value is transferred as soon as it exceeds the configured value.
The value is transferred as soon as it drops below the configured value.
Transfer once upon edge change at the digital input
Alternatively with edge change 1 → 0 or 0 → 1
Operating Instructions, 10/2019, C79000-G8976-C503-02
SIMATIC CC7
Advertisement
Table of Contents
