Introduction; F3 Tool Kit - Minelab F3 Service Manual

F3 Service Manual
Disassembly & Reassembly Procedures
3.4

Introduction

This section describes the procedures required to exchange line replaceable units.
Whenever a unit is replaced, mechanical and functional testing as described in section
3 Mechanical and Function Testing
3.5

F3 Tool Kit

The F3 Tool Kit (Part No 3004-0018) is required to disassemble and reassemble the
F3. The tool kit (Figure 10) comprises:
Minelab Part No
71-0005-0006
71-0005-0010
75-8701-0009
8701-0010
75-8701-0011
75-31400-010
75-31400-011
75-8701-0013
4904-0004
All tools except the F3 Coil Cable Pull Through are commonly available. If
necessary, a length of string can be used as the F3 Coil Cable Pull Through.
must be completed.
Table 5: Tools
Description
Silicon Grease (100g tube)
Silicon Sealant (75g tube)
Tubular Spanner 7/8"
F3 Coil Cable Pull Through
Screwdriver Pozidrive No 1
Hex Driver 2.5mm
Hex Driver 3.0mm
Flat blade screwdriver 6.5mm x 150m
Service Manual F3
Figure 10: Tool Kit.
NOTE
Page 22