Introduction - Minelab F3 Service Manual

1.

Introduction

a. Servicing the F3 Series of detectors comprises fault finding, repair and maintenance
and is designed to be simple and fast thereby reducing the amount of time a detector is
unusable. Repair and maintenance is based on line replaceable units which can be fitted to
a detector without the need for adjustment or calibration. Additionally, serviceable line
replaceable units can be exchanged between detectors as required.
b. Servicing the F3 can be conducted within the field (under clean and dry conditions) or
at local depots. No special tools are required, but it is recommended that the F3 Service
Tool Kit be used.
c. Servicing the F3 is restricted to the exchange of line replaceable units following the
identification of a faulty sub-assembly. Servicing DOES NOT include any repairs to printed
circuit boards as this is only conducted at a Minelab facility.
d. This manual should be read in conjunction with the F3 Operations Manual.
Additionally, from time to time, Minelab will issue Technical Service Notes which serve to
supplement the information contained in this manual.
e. Any questions regarding this manual or any repair procedure can be directed to
Minelab via the following internet link: http://minelab.com/
F3 Field Service Manual
Page 4