F3 Service Manual
Remove the electronics pack. Refer to section
Electronics Pack
Remove the coil. Refer to section
Using Figure 61 as a guide, use the 3mm hex driver (Allen key) or punch to
push out the two pins (Part 5) from the camlock lower
Remove the camlock body lower (Part 1) from the lower shaft.
Remove the lower shaft by pushing it back through the upper/middle shafts.
The pressure block can be replaced without the need to remove the electronics pack
and coil. Press out the pin through the camlock lever then remove the camlock lever
b.
To Disassemble the Camlock Middle and Middle Shaft:
Camlock
3004-0012
1
8008-0023
2
8008-0005
3
8008-0030
4
8008-0069
5
4308-0003
8007-0024
4.4.a. To Remove the Coil.
Note
to directly access the pressure block.
Kit
Middle
Figure 62: Camlock Middle.
Table 9: Camlock Kit Middle.
Camlock Kit Middle, contains items 1 to 5
Camlock Body Middle
Cam Lever
Wear Plate
Pressure Block Middle (include wear plate)
Pin Cam Lever
Middle Shaft (not part of camlock kit middle)
Page 60
4.3.a. To Remove the
Upper Shaft
Middle Shaft