Wiring Loom - Minelab F3 Service Manual


Carefully fit the left handle half to the right handle half and upper shaft. Ensure
both halves are secured to the upper shaft.
Hold the handle together tightly until the first two bolts have been fitted otherwise the
internal nut or main wiring loom may become dislodged. The four bolts should

Tighten the four bolts in the handle.
3.11

Wiring Loom.

To remove and exchange the wiring loom, it is necessary to remove the speaker pod,
disassemble the handle and disconnect the electronics pack from the upper shaft.
a. To Remove the Wiring Loom:

Remove the speaker pod, follow the instructions given in section
Remove the Speaker Pod.

Disassemble the handle, follow the instructions given in section
Disassemble the Handle.
Figure 47: Recess for Dust Cap.
NOTE
initially only be done up loosely.
Page 49
F3 Service Manual
4.6.a. To
4.7.a. To