Minelab F3 Service Manual page 58

F3 Service Manual
b. To Assemble the Armrest:

Position the right half of the armrest onto the upper shaft.

Fit the armrest pressure block, cam lever pivot pin and cam lever into the right
armrest half.

Carefully fit the left armrest half to the right armrest half and upper shaft.

Refit the three bolts and nuts.
If the armrest is difficult to slide on the upper shaft, the middle bolt may need to be
c. To Replace the Armstrap:

Thread the armstrap as shown in Figure 59.
Figure 59: Threading the Armstrap, view from coil.
NOTE
loosened.
Page 58