Minelab F3 Service Manual page 61


Using Figure 62 as a guide, use the 3mm hex driver (Allen key) or punch to
push out the pin (Part 5) from the camlock middle.

Remove the cam lever.

Remove the pressure block by pushing it out from inside the shaft.

Remove the middle shaft by pushing it back through the upper shaft.
c. To Disassemble the Camlock Upper:
3004-0013
1 8008-0030
2 8008-0005
3 8008-0068
4 4308-0003
5 8008-0021
6 8007-0023

Using Figure 63 as a guide, use the 3mm hex driver (Allen key) or punch to
push out the pin cam lever pivot (Part 4) from the upper camlock (Part 5).

Remove the cam lever.

Remove the upper pressure block by pushing the block out from inside the
shaft.

Remove the camlock body upper from the upper shaft.
Figure 63: Camlock Upper.
Table 10: Camlock Kit Upper
Camlock Kit Upper, contains items 1 to 5
Wear Plate
Cam Lever
Pressure Block Upper (includes wear plate)
Pin Cam Lever
Camlock Body Upper
Upper Shaft (Not Part Of Camlock Kit)
Page 61
F3 Service Manual