Minelab F3 Service Manual page 24

F3 Service Manual
The F3L electronics pack can be identified by a yellow dot or L on the rear of the
a. To Remove the Electronics Pack:

Remove battery pack and sensitivity endcap.

Remove the six screws (Part 10) holding the cover bulkhead (Part 9) to the
electronics pack rear panel.
Figure 12: Removing cover bulkhead from the Electronics Pack.

Pull the cover bulkhead away from the electronics pack.

Gently unplug the wiring loom plug from the electronics pack, as shown in
Figure 13.
Figure 13: Removal of Wiring Loom from Electronics Pack.
NOTE
housing.
NOTE
Page 24