Minelab F3 Service Manual page 44

F3 Service Manual

Remove the lower half of the speaker pod by lifting the rear of the pod upwards.
b. To Connect the Speaker Pod:

When replacing or reassembling speaker pods it is important to note that an
F3L speaker pod is only functional on an F3L configured detector. Similarly,
the standard F3 speaker pod is only functional on the F3 detector.
reassemble the speaker pod:

Ensure that the handle has been fully assembled and the wiring loom is in place.
Refer to section

Peel back the shroud at the end of the speaker pod plug as shown in Figure 41.

Attach the lower half of the speaker pod by inserting the tongue at the front top
of the handle into the recess in the lower half of the speaker pod. As shown in
figure
Figure 40: Old Speaker Pod.
4.7.b. To Assemble the
Figure 41: Speaker Pod connector shroud.
Page 44
Handle.
To