Volume; Res. Moisture Display; Visibility Parameters; Display Off Status - Miele PDR 910 EL SOM Operating And Installation Instructions

The date can be shown starting with the day, month or year.
Date
-
The date is set.

Volume

The volume for various sounds can be changed.
The volume can be changed for the following tones:
- Finish tone
The finish tone signals the end of the drying programme.
Keypad tone
-
- Welcome tone
Fault alarm
-
The fault tone signals a fault and can be switched off. The volume of the fault tone can-
not be adjusted.

Res. moisture display

In addition to displaying the drying level, the residual moisture can also be indicated as a
percentage.
Without % value
- Factory default:
- With % value

Visibility parameters

Various parameters are offered/displayed when a programme is selected. You can decide
which parameters should not be displayed. These parameters can then not be edited dur-
ing programme selection.
Residual moisture
-
Duration
-
Low temperature
-
- Anti-crease
Load size
-
Drying temperature
-

Display off status

The display switches off to save energy; only the Start/Stop sensor flashes slowly. You
can change this setting.
Changing this setting leads to increased energy consumption.
Off
-
No switching off
- On (10 min.) Not curr.prog.
The display will remain on during the programme sequence but will go out 10 minutes
after the end of the programme.
Supervisor level
45