Table of Contents
Advertisement
OPERATION
OPERATION
REMARK
If the ripper is applied with the rear of the machine raised from
the ground, the drawbar pull will be low, so the ripping efficiency
will be reduced.
If the ripping depth is kept constant, there will be no
unevenness, and this will increase the efficiency of the dozing
operation.
RIPPING BY CLIFFS
When carrying out ripping at the edge of a cliff, tilt the ripper back
(B) to make depth (L) longer.
Depress the decelerator pedal, drive slowly forward, and when
the ripper point contacts the cliff, tilt the ripper in (A).
RIPPING BY SLOPE FACES
(Giant ripper)
When carrying out ripping work at the edge of slope faces, make
the ripper tilt back (B) angle small, and if there is an area where
the slope face (1) has not been ripped, apply the ripper
diagonally.
(A)Length of track on ground
OPERATION
OPERATION
3 - 149
Advertisement
Chapters
Table of Contents
