Table of Contents
Advertisement
OPERATION
ADJUST MIRROR
Be sure to adjust the mirrors before starting work. If they are not adjusted properly, you cannot secure the visibility and may be
injured or may injure someone seriously.
Loosen nut (1) of the mirror and adjust the mirror to a position
where it gives the best view from the operator's seat.
In particular, be sure to adjust the mirror so that people at the rear
left or right of the machine can be seen clearly.
ADJUST JOYSTICK (PCCS LEVER)
After moving case (2) in order to adjust the position of the steering, directional, and gearshift lever, secure lock lever (1) into the
notched hole, making sure it is in the LOCK position. If it is not completely locked, the steering, directional, and gearshift lever
may unexpectedly move and cause damage, serious injury, or death.
The steering, directional, and speed lever (wrist control type single lever: joystick) can be adjusted by 100 mm (3.9
in) in 5 stages to the front or rear. Adjust to the most suitable position to match the adjustment of the operator's seat.
1. Pull up lock lever (1) to the FREE position (F) at the rear of case
(2) on left side of the operator's compartment.
2. With lock lever (1) pulled up, use your other hand to grip the
front of case (2), then move it forward with your left and right
hands. The joystick moves with case (2).
3. Move case (2) to the desired position until a click is heard.
Then pull up lock lever (1) and release it. Lock lever (1)
automatically returns to the LOCK position.
REMARK
PCCS: Palm command control system
3 - 112
WARNING
WARNING
OPERATION
Advertisement
Chapters
Table of Contents
