Table of Contents
Advertisement
OPERATION
CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL
Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil
temperature to go down before performing this operation.
1. Open the engine side cover on the left side of the chassis.
2. Remove dipstick (G), and wipe the oil off with a cloth.
3. Fully insert dipstick (G) into filler pipe, then remove it.
4. The oil level should be between the H and L marks on dipstick
(G).
If the oil level is below the L mark, add oil through oil filler port
(F).
5. If the oil is above the H mark, drain the excess engine oil from
drain plug (P), and check the oil level again.
6. If the oil level is correct, tighten the oil filler cap securely and
close the engine side cover.
REMARK
Check the oil level with the engine stopped.
When checking the oil level immediately after stopping the engine, wait for at least 15 minutes after stopping the
engine before starting the inspection operation.
If the machine is at an angle, set it in a level position before starting inspection.
When adding oil, remove the dipstick from the guide to remove the air inside the crankcase.
WARNING
OPERATION
3 - 103
Advertisement
Chapters
Table of Contents
