Before every journey, make sure that the ISOFIX
child restraint system or the i‑Size child restraint
system is engaged correctly in both ISOFIX or
i‑Size mounting brackets.
* NOTE Damage to the seat belt for the
centre seat during installation of the child
restraint system
Make sure that the seat belt is not trap-
#
ped.
Vehicles with reclining rear seats: before an
#
ISOFIX or i-Size child restraint system is instal-
led, tilt the backrest of the reclining rear seat
back slightly.
Fold upholstered lining
1
upwards.
#
Pull the tab on upholstered lining
#
and position it on the support surface.
Upholstered lining
1
will remain folded
upwards.
Attach the ISOFIX or i‑Size child restraint sys-
#
tem to both mounting brackets
cle.
To close, fold upholstered lining
#
Lift the tab from the support surface and slide
#
it back into the upholstery slot between the
seat backrest and seat cushion. Close the
upholstery flap.
Vehicles with reclining rear seats: return the
#
reclining rear seat backrest to an upright posi-
tion.
The reclining rear seat backrest must be in
contact with the child restraint system.
Fastening a Top Tether
& WARNING Risk of injury or death from
adjusting the seat after fitting a child
restraint system
Vehicles with electrically adjustable rear
1
upwards
bench seats:
The following may occur:
The Top Tether belt may sit either too loose
R
or too tight
2
The child restraint system may be loose,
in the vehi-
R
incorrectly positioned or damaged and
then not perform its intended protective
1
upwards.
function.
Never adjust the seat after the child
#
restraint system has been installed.
Occupant safety
77