Table of Contents
Advertisement
448 Breakdown assistance
Affix part
1
of the TIREFIT sticker to the
#
instrument cluster within the driver's field of
vision.
Affix part
2
of the TIREFIT sticker near the
#
valve on the wheel with the defective tyre.
Pull plug
6
with the cable and hose
#
of the tyre inflation compressor housing.
Push the plug of hose
#
tyre sealant bottle
Place tyre sealant bottle
#
into recess
2
sor.
Remove the valve cap from valve
#
faulty tyre.
Screw filling hose
#
Insert plug into
#
cle.
5
out
Switch on the ignition.
#
5
into flange
4
of
3
until the plug engages.
3
head downwards
of the tyre inflation compres-
7
on the
8
onto valve 7.
6
a 12‑V‑ socket in your vehi-
Switch on the tyre inflation compressor using
#
On/Off switch 1.
The tyre is inflated. First, tyre sealant is pum-
ped into the tyre. The pressure may briefly rise
to approximately 500 kPa (5 bar/73 psi).
Do not switch off the tyre inflation compressor
during this phase!
Let the tyre inflation compressor run for a
#
maximum of ten minutes.
The tyre should then have attained a tyre pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tyre sealant leaks out, make sure you clean the
affected area as quickly as possible. It is prefera-
ble to use clean water.
If you get tyre sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
lene.
If, after ten minutes, a tyre pressure of 200 kPa
(2.0 bar/29 psi) has not been attained:
Switch off the tyre inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tyre.
Advertisement
Table of Contents
