Table of Contents
Advertisement
200 Climate control
The 48 V battery is not fully charged.
R
The running time of pre-entry climate control may
be reduced in the following circumstances (plug-in
hybrid):
The vehicle is not connected to power supply
R
equipment.
The high-voltage battery is not fully charged.
R
With active pre-entry climate control, the charge
level of the 48 V battery or the high-voltage bat-
tery may be reduced, even if the charging cable
connector is connected.
If present, seat ventilation will be activated in
cooling and ventilation modes.
Depending on the vehicle's equipment, the follow-
ing functions will be activated in heating mode, if
available:
Seat heating
R
Steering wheel heater
R
Panel heating
R
Mirror heater
R
Rear window heater
R
Windscreen heater
R
When the set temperature is changed, climate
control mode will automatically be updated and
switched from heating mode to ventilation or cool-
ing mode, from cooling mode to ventilation or
heating mode or from ventilation mode to heating
or cooling mode.
Setting pre-entry climate control for departure
time via the climate bar
Multimedia system:
Climate menu
Pre-entry climate ctrl
4
5
Setting the departure time
%
The set departure times are used for the vehi-
cle's pre-entry climate control and for predic-
tions regarding the approximate state of
charge and range at the time selected. Addi-
tional information on the charging settings:
(
page 389).
/
Edit departure time
u.
Select
#
Select a departure time or set a new depar-
#
ture time.
%
If the range maximisation function is activa-
ted, an approximate time for reaching the
desired state of charge is automatically deter-
mined during a charging stop. This is used as
an approximate departure time for pre-entry
climate control and is set automatically.
Departure times previously set cannot be edi-
ted when the function is switched on. The
automatically determined departure time can
be activated or deactivated via the air condi-
tioning menu.
Setting the repeat days
Select
Edit departure time
u.
#
Set the desired departure time and select the
#
corresponding weekdays on which this depar-
ture time is to apply.
Press
OK
to confirm.
#
Selecting seats
Select Driver, Passenger,
Rear left
#
right.
Pre-entry climate control will take place for
the selected seats.
or
Rear
Advertisement
Table of Contents
