Solid Fuel Measurement - TESTO Next-Gen 300 Instruction Manual

9 Performing the measurement

Solid fuel measurement

9.5.3
For performing solid fuel measurements complying with the 1st
BlmSchV, a Next-Gen testo 300 is required with the following
equipment:
CO sensor H2-compensated for measurements (measuring range for
•
1st BImSchV measurement min. 20,000 ppm.
Testo 300 Industrial - 30,000 ppm)
Measuring range extension by fresh air dilution
•
Solid fuel adapter and probe shaft with pre-filter 0600 9765
•
1
Call up function:
2 |
| Options | Averaging | On
3
Zeroing is carried out.
 The list for averaging opens.
The start button changes to
4
Confirm with
5
Enter measuring time (15 min). The required value can be entered in
the field.
6
Confirm with
7
Insert the flue gas probe into the exhaust pipe and position it in the hot
spot.
8
1
Start averaging with

Stability time starts.
Press

After a maximum of 3 minutes, the stabilisation time ends and
the measurement starts automatically.

The system records the readings in the set measuring cycle.
During the measurement, the readings and the calculated
values are displayed.

Readings are automatically saved.
60

The measuring result is displayed after the measuring phase has
been completed.
| Flue Gas
.
.
.
.
Continue
to end the stability time manually.