Installing Expansion Cards - Supermicro SuperServer SYS-110C-FHN4T User Manual

Before following the procedure below to install expansion cards, first turn off and remove
power from the system as described in

Installing Expansion Cards

1. Remove any slimline SAS cables connected to the riser card and pull up the riser card
brackets.
•
For the right side (looking from the node rear), open the clip of each slot on the right.
•
For the left side, open the clip of each slot.
2. Remove the blank PCI shield from the chassis.
3. Slide the expansion card shield into the open shield slot while plugging the expansion
card into the riser card.
Chapter 3: Maintenance and Component Installation
section 3.1
Figure 3-13. Installing Expansion Cards
42
then remove the top cover.