Installing A Door Catch Onto The Lower Right Of A Frame - Nortel Passport 15000 Hardware Installation And Maintenance

416 Chapter 17 Hardware procedures

Installing a door catch onto the lower right of a frame

Prerequisites
Procedure steps
241-1501-240 5.2S2
Install a door catch onto the lower right front or rear of a NEBS 2000 frame
to enable keeping a door closed and locking it.
• You must be familiar with "Safety considerations and best practices"
(page 53).
• You need a door catch from kit NTRU0192 as shown in the figure "A
lower door catch P0884950" (page 417) and "A lower right extension
bracket P0995493" (page 404) that is already installed onto the base of
the NEBS 2000 frame from another procedure.
• You need 4 Pozidriv screws P0600060 and 4 lock washers P0600895
from kit NTPX4060 as shown in the figure "Types of screws used with
frame enclosure hardware" (page 120).
1 Align the holes of the catch with the holes on the outside of the lower
extension bracket as shown in the figure "Orientation of a cosmetic filler,
a lower door catch, and a lower right extension bracket" (page 405).
2 Loosely fasten the door catch through the extension bracket using 4
Pozidriv 12-mm screws P0600060 each with a lock washer P0600895.
Drive the screws from the direction shown in the figure so that the parts
are assembled as shown in the figure "Orientation of an installed cosmetic
filler, door catch, and extension bracket" (page 420).
3 Tighten all screws to snug plus a 1/4 turn.