Nortel Passport 15000 Hardware Installation And Maintenance page 838

838 Chapter 17 Hardware procedures
241-1501-240 5.2S2
8 Route the remainder of the cable up to the BIP and along the strain relief
bar at the rear of the BIP. Cut the cable so that it can easily reach the rear
stud on the BIP from a right-angled turn off the strain relief bar.
If the BIP is to be equipped with a power-and-ground assembly
(A0834143 or A0834149), each cable must be routed above the BIP,
permanently suspended from above, and routed down past the
appropriate terminal block. Cut each cable at the strain relief bar.
9 Wrap the end of the cable in electrical tape and leave it hanging.
10 Permanently label the cable as indicated in the figure "Overhead power
input cables for the lower shelf connected to the BIP" (page 839), for
example, B1+. Position the label so it can be easily read and traced to
termination after all cables are installed.
11 Repeat step 4 to step 10 for the remaining power cables. Install them 1 at
a time, end to end, from right to left across the rear of the BIP. (The bottom
Passport 15000 or 20000 is powered from the studs on the left half of the
rear of the BIP.)
12 Fasten the bottom plate back onto the frame.