Removing A Multiport Aggregate Device - Nortel Passport 15000 Hardware Installation And Maintenance

Hide thumbs Also See for Passport 15000:

Table of Contents

704 Chapter 17 Hardware procedures

Removing a multiport aggregate device

Prerequisites

Procedure steps

241-1501-240 5.2S2

Remove a multiport aggregate device from a Passport cabinet, frame or non-

Passport mounting apparatus to replace a failed device or to decommission

You must be familiar with "Safety considerations and best practices"

Lock any affected ports before removing a multiport aggregate device.

On the rear of the unit, turn the power switch for each power supply to the

off position.

Turn off the power source to the outlet that feeds the device. Put electrical

tape on the breaker or over the fuse hole to indicate deliberate action.

Label the cables connected to the device.

Remove all of the cables from the device and coil them out of the way.

Remove the 5/16-in. screws that fasten the device's brackets to the

adapter brackets of a frame or the uprights of its mounting apparatus.

Support the device while the last screws are unfastened, and remove the

device. The device weighs 2 kg (4.4 lbs).

If you are returning the device to Nortel Networks for repair, label the

device. Include the failure time, date, fault, your name, organization,

department, telephone number, and the multiport aggregate device part

and serial number. Then, pack the device in its original packaging.

Show Quick Links

Table of Contents

Passport 20000