Table of Contents
Advertisement
2- 2 MEMORY INSTALLATION
WARING !!!
• Make sure that you unplug your power supply when adding or removing
memory modules or other system components, failure to do so may
cause severe damage to both your mainboard and expansion cards.
• Be careful when inserting or removing DIMM, forcing a DIMM in or
out of a socket can be damaged the memory module or the socket. Some
of DIMMs contain EDO or FTP DRAM that accept only 5V power. These
DIMM types are incompliant with the mainboard, the M/B only supports
3.3V true SDRAM DIMMs.
Installing DIMM
• Make sure you have the correct memory module type for your mainboard.
• Insert the module(s) as shown below, DIMMs have 168-pins and two
notches that will be matched by the onboard DIMM socket. Memory mod-
ules are installed by inserting them straight into the slot until they "click" in
the right place. They only fit in one direction, so do not force them in by a
wrong direction.
168-Pin DIMM Notch Key Definitions(3.3V)
DRAM Key Position
Removing DIMM
• Press down the holding clips on both sides of a DIMM socket and the
module will be released from it.
Voltage Key Position
Unbuffered
3.3V
17
Chapter 2 Hardware Setup
Advertisement
Table of Contents
