SOLTEK SL-65KV2-T User Manual page 65

Init Display First Initialize the AGP video display before initializing any
IDE HDD Block Mode Block mode is also called block transfer, multiple
Onboard FDD
Controller
Onboard Serial
Port 1 / Port2
UART 2 Mode The second serial port on your system may offer a
IR Function Duplex This item allows you to select the IR half / full duplex
other display device on the system. Thus the AGP
display becomes the primary display.
The choices: PCI Slot; AGP.
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can
support.
The choices: Enabled; Disabled.
Select Enabled if your system has a floppy drive con-
troller (FDC) installing in the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choices: Enabled; Disabled.
Select an address and corresponding interrupt for the
first and second serial ports.
The choices: 3F8/IRQ4; 2E8/IRQ3; 3E8/IRQ4;
2F8/IRQ3; Disabled; Auto.
variety of infrared port modes. Click here for a
description of various modes. (Click your browser's
Back button, or your right mouse button, to return to
this page.)
The choices: Standard; HPSIR; ASKIR.
function.
The choices: Half; Full.
65
Chapter 4 BIOS Setup