Memory Installation - SOLTEK SL-65EP User Manual

2-3 MEMORY INSTALLATION

WARING !!!
• Make sure that you unplug your power supply when adding or removing
memory modules or other system components, failure to do so may cause
severe damage to both your motherboard and expansion cards.
• Be careful when inserting or removing DIMM, forcing a DIMM in or out of a
socket can be damaged the memory module or the socket. Some of DIMMs
contain EDO or FPM DRAM. These DIMM types are incompliant with the
motherboard, the M/B only supports 3.3V Non-ECC SDRAM DIMMs.
Installing DIMM:
• Make sure you have the correct memory module type for your motherboard
• Insert the mdule(s) as shown, DIMMs have 168-pins and two notches that
will match with the onboard DIMM socket, memory modules are installed by
inserting them straight into the slot until they "click" into place. They only fit
in one direction so do not force them into place.
Removing:
• Press the holding clips on both sides of socket out ward to release the
DIMM, Gintly pull the DIMM out of the socket.
CPUFA1
1 3
JP2
JP8
JP9
JP10
1 3
RT1
AUXFA1
168-Pin DIMM Notch Key Definitions(3.3V)
DRAM Key Position Voltage Key Position
Unbuffered
3.3V
ATX POWER
Clock
Generator
Intel
815EP
MCH
NOTICE : When LED1 light is on ,
meaning that 3.3V is conducting DIMM
slots , please do not add or remove
memory modules .
65EP / 65EP+
17