YASKAWA SI-S3 Installation Manual page 23

A - Insertion point for CN5 connector
B - Option
C - Included screws
D - Drive front cover
E - LED label
Install the Option
Use this procedure to install the option.
DANGER
energized drive. Before servicing, disconnect all power to the equipment and wait for the time specified on
the warning label at a minimum. The internal capacitor stays charged after the drive is de-energized. The
charge indicator LED extinguishes when the DC bus voltage decreases below 50 Vdc. When all indicators
are OFF, measure for dangerous voltages to make sure that the drive is safe. If you do work on the drive
when it is energized, it will cause serious injury or death from electrical shock.
YASKAWA TOEP C730600 85A CANopen Installation Manual
Figure 5.8 Drive Components with Option
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an
F - Keypad
G - LED Status Ring board
H - Connector CN5-A
I - Connector CN5-B (Not available
for communication option
installation.)
J - Connector CN5-C (Not available
for communication option
installation.)
5 Installation Procedure
23