REMKO Smart Control Touch Operating Manual page 84

REMKO Smart-Control Touch
Solar heat meter - medium flow rate probe
The amount of heat delivered from solar yields is recorded continuously, and can be called up in the form of
a daily or cumulative value.
If no medium flow rate probe is installed, a manual medium flow rate can be selected. The heat meter can
also be deactivated, if desired.
Menu item
Solar HM
Setting the impulse rate of the solar medium flow rate probe
The impulse rate must only be changed if the impulse rate in the customer-provided system must be
adapted.
Menu item
Impulse rate for medium flow rate
(if activated)
Manual medium flow rate
If no medium flow rate probe is installed in the solar station, a manual medium flow rate can be selected. The
heat meter can also be deactivated, if desired.
The medium flow rate is specified in order to calculate the amount of solar heat.
The value can be viewed on the flow meter when the solar pump is running.
Then set the value.
Recommendation:
adjust the medium flow rate to suit the hydraulic system provided by the customer
Set temperature of the storage tank during solar charging
Once the solar set temperature is reached, the solar cycle pump is switched off. With the collector cooling
function activated, the temperature of the storage tank can continue to rise as far as the set maximum tem-
perature.
The solar set temperature should be reduced if the hot water temperature is regularly too high or if there is
no thermostatic mixing valve installed. At the same time, when the collector cooling function is activated, the
max. temperature of the storage tank must be reduced.
Menu item
Solar set temperature
REMKO recommends installing a domestic hot water mixer with solar hot water preparation.
WARNING!
Implement measures on site to ensure sufficient scalding protection!
84
Parameter
Deactivated
Manual medium flow rate
Medium flow rate probe
Parameter
0 - 10 ml/Imp
Parameter
5 °C - 95 °C
Factory setting
Setting with heat meter
installed
Factory setting
5.7 ml/Imp
Factory setting
85 °C