REMKO Smart Control Touch Operating Manual page 104

REMKO Smart-Control Touch
ID Description
Negative temp. differ-
ID7333
ential
ID7334 Comm. signal
Warnings
ID Description
ID8001 Driver offline
ID8002 Driver offline
System temperature
ID8100
too low
Medium flow rate too
ID8101
low
Temperature discrep-
ID8102
ancy in solar cycle
ID8103 Overnight collector
temperature
ID8104 Medium flow rate too
low
ID8105 Set medium flow rate
ID8107 Compressor status
ID8108 Compressor start error
ID8109 EVD EVO probe fault
ID8110 Driver offline
ID8111 Room sensor offline
ID8112 Room sensor offline
ID8113 Room sensor offline
ID8114 Room sensor offline
ID8115 Room sensor offline
Anti-freeze protection
ID8132
active
HW storage tank set
ID8138
temp.
Lower application area
ID8139
(heating)
Upper application area
ID8140
(heating)
Lower application area
ID8141
(cooling)
104
Desig. Details
The temperature difference when the heat generator is active
is implausible
Communication between operating unit SMT 1 and power unit
SMT 1 I/O was interrupted.
Desig. Details
µPC2
EVD EVO probe fault
µPC2
Driver offline
The system temperature is too low to start the heat pump.
The medium flow rate is too low to start the heat pump
The collector temperature is at least 60K higher than the
storage tank temperature
A collector temperature of at least 45°C occurred overnight
HP 2 The medium flow rate is too low to start the heat pump
HP1 The flow rate has dropped below the set medium flow rate
The active operating mode is safety mode because the com-
pressor is active without demand
µPC
Compressor start error
µPC
EVD EVO probe fault
µPC
Driver offline
The room sensor for the unmixed circuit was not detected
The room sensor for the 1st mixed circuit was not detected
The room sensor for the 2nd mixed circuit was not detected
The room sensor for the 3rd mixed circuit was not detected
The room sensor for the 4th mixed circuit was not detected.
The anti-freeze protection function is currently active - check
the room climate mode set
The hot water storage tank set temperature was reduced due
to low outside temperatures
The temperature has currently dropped below the guaranteed
application area of the external unit in heating mode
The guaranteed application area of the external unit in heating
mode is currently exceeded
The temperature has currently dropped below the guaranteed
application area of the external unit in cooling mode