REMKO Smart Control Touch Operating Manual page 80

REMKO Smart-Control Touch
Impulse-guided circulation - Disable switch-on
After the running time of the circulation pump, the pump cannot be started again while disable switch on is
active. This prevents unnecessary permanent operation of the pump in the case of continuous dispensing. If
the hot water cools too much while disable switch-on is active, the time should be shortened.
Then select the desired time.
Menu item
Impulse-guided circulation -
Disable switch-on
Unmixed cycle
Optionally, you can activate or deactivate the "Unmixed circuit" function.
Menu item
Unmixed cycle
Operating mode
Select the operating mode for the unmixed circuit.
Setting heating circuit mode
This is where you can select between the different heating circuit modes. The choice is between control
according to the set "heating curve" and "fixed value regulation".
Menu item
Operating mode unmixed circuit
After activating the unmixed mixed heating cycle, the 1st mixed heating cycle is enabled, and
after activating the 1st mixed heating cycle, the 2nd mixed heating cycle is enabled.
In case of the cascading of two heat pumps, the 3rd and 4th mixed heating cycle are also ena-
bled.
The descriptions of the 1st and 2nd mixed heating cycle are identical to the unmixed heating
cycle.
The mixed heating cycles each require a supply and return probe! These probes are included in the scope of
supply of the mixed REMKO heating circuit groups.
80
Parameter
1 min - 15 mins
Parameter
Deactivated
Activated
Parameter
Heating
Cooling
Heating and cooling
Factory setting
5 min.
Factory setting
Deactivated
Factory setting
As required