REMKO Smart Control Touch Operating Manual page 70

REMKO Smart-Control Touch
"Settings" menu item
Manual mode - relay test
With this menu item, you can control the individual actuators (pumps, mixing valves, etc.) manually or specify
values of probes for checking.
Parameter
Manual mode
Pump 2nd mixed cycle
Speed
Pump 4th mixed cycle
Speed
"Settings" menu item
Manual mode - probes
Parameter
Manual mode
Collector temperature
Temperature
Storage tank temperature, lower
Temperature
Solar inlet temperature
Temperature
Solar return temperature
Temperature
Circulation paddle switch
Circulation temperature
Temperature
2nd mixed cycle inlet temperature
Temperature
4th mixed cycle inlet temperature
Temperature
70
(continued) - Expert
(continued)
(continued) - Expert
Permanent / Deactivated / 15 minutes
A46
A46
A46.2
A46.2
Permanent / Deactivated / 15 minutes
S01
S01
S02
S02
S03
S03
S04
S04
S05
S05
S05
S06
S06
S06.2
S06.2
Selection parameter
Auto / On / Off
10 % - 100 %
Auto / On / Off
10 % - 100 %
Selection parameter
Probe value
Default value
-60°C - 250°C
Probe value
Default value
-60°C - 250°C
Probe value
Default value
-60°C - 250°C
Probe value
Default value
-60°C - 250°C
Off / On / Auto
Probe value
Default value
-60°C - 250°C
Probe value
Default value
-60°C - 250°C
Probe value
Default value
-60°C - 250°C