Table of Contents
Advertisement
GEARS
• Lube Type: NLGI#2 equivalent grease
• Lube Amount: Thin coat
• Lube Frequency: Every 90 Hours of
operation
TO LUBRICATE GEARS
1. Disconnect the machine from the
power supply.
2. Remove the cover from the gearbox.
3. Using a small brush, apply a thin coat
of grease to the headstock gears.
4. Re-install the gearbox cover
removed in step 2.
5. Operate the saw to work the grease
through the gears.
BLADE CHANGE
The blade should be changed when it becomes dull, damaged or when you
are using materials that require a blade of a certain type or tooth count (see
page 31 for replacement blades).
TO CHANGE THE BLADE
1. Disconnect the machine from the power source.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
25
Advertisement
Table of Contents
Need help?
Do you have a question about the METALWORKER CBS7MC and is the answer not in the manual?