Installing Work Stop - Clarke METALWORKER CBS7MC Operation And Maintenance Instruction

Hide thumbs Also See for METALWORKER CBS7MC:

Table of Contents

1. Unbolt the shipping bracket shown

here.

NOTE: Retain all components, as the

bracket can be reinstated if the

bandsaw needs transporting/

shipping in the future.

INSTALLING WORK STOP

1. Insert the work stop rod through the hole in

the base and lock in place with a hex key

and screw.

2. Slide work stop over the rod.

3. Measuring from the outside of the blade,

tighten the thumbscrew to set the work

stop at the desired length.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

Table of Contents

Do you have a question about the METALWORKER CBS7MC and is the answer not in the manual?

6460123